关于数值变量显示问题

13460332002

这些都对，为什么显示还是整数位没有小数点

Cp`sir

数值转换：http://doc.gz-dc.com/Modbus/Ctrls/01_Mb_basic.html 参考此链接

hgq21102

内存变量是不能缩放的

terefere

Hi, I have similar problem. I set variable as 0,1 zoom (like in manual). My modbus register have 321 but at screen I see 321.0 instead 32.1

If后要接end

terefere 发表于 2022-5-6 02:31
Hi, I have similar problem. I set variable as 0,1 zoom (like in manual). My modbus register have 321 ...

did you have save this setting and redownload this project to the screen？

terefere

Sure, I try to set also "translation" and display format- this works, I see change. Only "zoom" not work as I read and think.

If后要接end

terefere 发表于 2022-5-6 16:06
Sure, I try to set also "translation" and display format- this works, I see change. Only "zoom" not  ...

Can you give me the DeviceType of your screen?

terefere

from sticker: DC12480EW068 1VW1 OC 1G V1Q11
Device in project settings DC12480EW068

If后要接end

terefere 发表于 2022-5-6 23:21
from sticker: DC12480EW068 1VW1 OC 1G V1Q11
Device in project settings DC12480EW068

You can download this project in your screen to test. This packet also has modbus slave file, you can use modbus slave software to connect screen to test. If this project cannot be realized, please tell me HW ver on your screen.

terefere

I burn it into screen but not switch on modbus- I see that you init variable to 32 at reset time but the same like previous time is displayed as 032.0 instead 3.2.